Categories
Dromet PSRe M8x130/60 ring shield anchor, galvanised steel
0
Description
Dromet PSRe M8x130/60 ring shield anchor, galvanised steel
The Dromet PSRe 8x130/60 ring anchor is a proven solution for permanent fixing of mounting profiles, metal structures, grilles, railings, machinery and other building fittings. It has been designed for non-cracked concrete min. B20, dense natural stone and solid brick substrates — typical substrates found on photovoltaic, industrial and infrastructure sites.
The ring design with nut and washer ensures reliable expansion in the mounting hole and high load capacity. The anchor is made of structural steel with corrosion protection in the form of electro-galvanising, which guarantees corrosion resistance in indoor and moderately humid conditions.
Certificates and approvals
The anchor holds European Technical Approval ETA 05/0242 and CE certification, and is also covered by the national approval AT-15-7574/2008. This means it can be used in critical structural fixings where documented load capacity and compliance with standards are required.
Technical parameters
- Manufacturer: Dromet
- Type: ring shield (expansion) anchor PSRe
- Thread: M8
- Total length (L): 130 mm
- Drill diameter (Ø): 8 mm
- Thickness of fixed element (E): 60 mm
- Anchorage depth (F): 65 mm
- Hole depth (D): 100 mm
- Material: structural steel
- Corrosion protection: electro-galvanised
- Weight: 0.046 kg
- EAN: 5907518696792
- Sales unit: piece
Installation diagram and dimension markings
The cross-section drawing illustrates the correct installation of the anchor in a concrete substrate. Key installation dimensions marked on the diagram:
- M — anchor thread diameter
- E — thickness of the fixed element (distance from the substrate surface to the nut)
- F — anchorage depth in the substrate
- L — total length of the anchor
- D — minimum depth of the drilled hole
- H — diameter of the drilled hole
Installation recommendations
- The mounting hole should be drilled perpendicular to the substrate surface and thoroughly cleaned of dust
- Insert the anchor into the hole using light hammer taps
- Tighten using a torque wrench — do not exceed the torque value specified in the approval
- After the anchor has expanded, the washer under the nut must be firmly pressed against the fixed element
- Installation and load-bearing parameters in accordance with Technical Approval AT-15-7574/2008 — these must not be exceeded
Use in photovoltaic installations
The PSRe M8 anchor is widely used by installation teams for anchoring PV support structures in concrete ceilings, walls and foundations. Thanks to ETA and CE certification, it provides a reliable fixing that meets design requirements and facilitates technical acceptance of installations.